Cardinal 7550 User Manual download pdf (Page 4)

INSTALLATION

Location

The scale should be installed in a location with a flat, level floor. Note that the weighing

platform will not sit completely against the floor. This will not affect the accuracy of the scale

as the weighing platform will settle to the floor when the patient is placed on the scale.

form will be off the floor. The back

Back Load Cell

Front Load Cell

1/8” – 1/4” Clearance

The front load cells of the weighing plat

load cells must be sitting completely

There should be 1/8” to 1/4” clearance between

the sides of the scale frame and the floor. This

clearance is required for the lift mechanism to

close completely. The included shims can be

used to raise the scale if there are slight

imperfections with the floor or wall mount

installation that sits the wall mount too low and

prevents the scale from closing completely. If

on the floor.

the wall mount is too high the back load cells

will not touch the floor when the weighing

platform is lowered. If the wall mount is too

high, the wall mount must be moved lower on

the wall or the scale will not function correctly.

NOTE: It may be necessary to remove any base molding/chair rail/wall guard or to remove a

section of the base molding/chair rail/wall guard to provide space to mount the scale in a true

vertical position. An alternative method would be to shim the wall mount away from the wall to

accommodate any base molding/chair rail/wall guard.

0065-0647-OM Rev A  7550 FOLD-UP STATIONARY SCALE

1 2 3 4 5 6 7 8 9 10 11

No comments

Cardinal 7550 User Manual Page 4