Cardinal Detecto 6735 Owner's Manual download pdf (Page 10)

INSTALLATION, CONT.

Serial I/O Port

The 758C RS-232 serial I/O port is a 9-pin "D" connector on the rear

panel of the indicator. Figure No. 3 shows the Serial I/0 connector

along with the identity of the pins used. Make certain that the pins

are correctly identified before soldering a wire to them. Use t

connector retaining screws to hold the serial cable connector securely

to the rear panel.

Figure No. 3

PIN NO. FUNCTION

2 DATA INPUT (RXD)

3 DATA OUTPUT (TXD)

5 SIGNAL GROUND (GND)

Note that pins 1, 4 and 6 through 9 are not used.

The 758C RS-232 serial interface can be configured during the setup

and calibration procedure or during the setup review operation. Using

either method, it is possible to select the operation of the serial

interface as well as select the baud rate.

x The baud rates supported are: 1200, 2400, 4800, 9600, 19.2K

and 38.4K baud.

x The data format is fixed at 8 bits, No parity, and 1 stop bit.

x The indicator is shipped from the factory with the baud rate set

to 9600 baud.

Ethernet (Optional)

The 758C Ethernet option requires the purchase of the optional 758-IP Ethernet Interface

Option. Once installed, connections to the 758C are by CAT 5 or equivalent cable. Consult

your network administrator for the proper procedure to terminate and connect the cable.

BATTERIES

The 758C indicator can use 6 "C" size Alkaline, Ni-Cad or NiMH batteries (not included). You

must first obtain and install batteries before operations can begin. Batteries are contained in a

battery holder inside indicator. Access is via a removable panel on back of indicator.

CAUTION! The 758C can be operated from Alkaline, Ni-Cad or NiMH batteries. All

six (6) batteries must be of the same type. They must all be Alkaline, all Ni-Cad or

all NiMH. DO NOT mix Alkaline and Ni-Cad or NiMH batterie

IMPORTANT! The 758C does

not have a battery charging circuit. Should you wish

to use Ni-Cad or NiMH batteries, they must be fully

charged before installing. When

discharged, Ni-Cad or NiMH batteries must be removed and placed in an external

charger to recharge.

CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT

TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

ATTENTION: RISQUE D'EXPLOSION SI LA BATTERIES EST REMPLACE'E PAR UN

TYPE INCORRECT. REJETEZ LES BATTERIES UTILISE'ES SELON LES

INSTRUCTIONS.

8555-M210-O1 Rev R y 758C Owner’s

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Comments to this Manuals

No comments

Cardinal Detecto 6735 Owner's Manual Page 10

Comments to this Manuals

Related products and manuals for Kitchen scales Cardinal Detecto 6735